Dell Force10 Z9000 - Show Cam Mac Linecard (Count)

Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.5.1.0 Introduced on the E-Series.
show cam mac linecard (count)
Display the content addressable memory (CAM) size and the portions allocated for MAC addresses and for MAC ACLs.
E-Series, S4810
Syntax
show cam mac linecard slot port-set port-pipe count [vlan vlan-
id] [interface interface]
Parameters
linecard slot (REQUIRED) Enter the keyword linecard followed by a slot number
to select the linecard for which to gather information. The E-Series
range is 0 to 6.
port-set port-pipe (REQUIRED) Enter the keywords port-set followed by a Port-Pipe
number to select the Port-Pipe for which to gather information. The E-
Series range is 0 or 1.
count (REQUIRED) Enter the keyword count to display CAM usage by
interface type.
interface
interface
(OPTIONAL) Enter the keyword interface followed by the
interface type, slot and port information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel
followed by a number. The E-Series range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword sonet followed by
the slot/ port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
926