Dell Force10 Z9000 - Fefd

Parameters
events Enter the keyword events to enable debugging of FEFD state
changes.
packets Enter the keyword packets to enable debugging of FEFD to view
information on packets sent and received.
interface (OPTIONAL) Enter the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a SONET interface, enter the keyword sonet followed by
the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/ port information.
Command Modes EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.12.0 Introduced on the S4810.
Legacy E-Series
command.
Related
Commands
• fefd – enables far-end failure detection on an interface.
• fefd reset – enables FEFD globally on the system.
fefd
Enable far-end failure detection on an interface.
E-Series, Z-Series, S4810
Syntax
fefd
To disable FEFD on an interface, use the no fefd command.
Defaults Disabled.
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
950