line
Enter a text string for your MOTD banner the message with your
delineator. The delineator is a percent character (%).
Defaults No banner is configured.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command
Usage
Information
A MOTD banner message is displayed only in EXEC Privilege mode after entering the enable
command followed by the password. These banners are not displayed to users in EXEC (non-
privilege) mode.
Related
Commands
banner exec – enables the display of a text string when you enter EXEC mode.
banner login – sets a banner to be displayed after successful login to the system.
cam-audit linecard
Enable audit of the IPv4 forwarding table on all line cards.
E-Series
Syntax
cam-audit linecard all ipv4-fib interval time-in-minutes
Parameters
all Enter the keyword all to enable CAM audit on all line cards.
ipv4-fib Enter the keyword ipv4-fib to designate the CAM audit on the
IPv4 forwarding entries.
interval
time-in-
minutes
Enter the keyword interval followed by the frequency in minutes
of the CAM audit. Range: 5 to 1440 minutes (24 hours). Default:
60
minutes.
Defaults Disabled
Command Modes CONFIGURATION
Command History
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
Enables periodic audits of the software and hardware copies of the IPv4 forwarding table.
101
To Next Page
Loading...
