Dell Force10 Z9000 - Redistribute

Parameters
interface Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For Loopback interface, enter the keyword loopback
followed by a number from zero (0) to 16383.
• For a Port Channel interface, enter the keywords port-
channel
followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword sonet followed by
the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
Defaults Not configured.
Command Modes ROUTER ISIS
Command History
Version 8.3.12.0 Introduced on the S4810.
Usage
Information
Although the passive interface neither sends nor receives routing updates, the network on that
interface is still included in the IS-IS updates sent using other interfaces.
redistribute
Redistribute routes from one routing domain to another routing domain.
E-Series, S4810
Syntax
redistribute {static | connected | rip} [level-1 | level-1-2 |
level-2] [metric
metric-value] [metric-type {external |
internal}] [route-map map-name]
To end redistribution or disable any of the specified keywords, use the no redistribute
{static | connected | rip} [metric metric-value] [metric-type
{external | internal}] [level-1 | level-1-2 | level-2] [route-
map
map-name] command.
Parameters
connected Enter the keyword connected to redistribute active routes into IS-
IS.
rip Enter the keyword rip to redistribute RIP routes into IS-IS.
static Enter the keyword static to redistribute user-configured routes
into IS-IS.
889