Dell Force10 Z9000 - Max-Paths

Parameters
prefix-list name Enter the name of the prefix list.
NOTE: There is a 140-character limit for prefix list names.
Defaults none
Command Modes CONFIGURATION
Command History
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.10.0 Introduced on the S4810.
Related
Commands
show ipv6 prefix-list – View the selected IPv6 prefix-list.
max-paths
Configure the maximum number of parallel routes (multipath support) BGP supports.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
max-paths {ebgp | ibgp} number
To return to the default values, enter the no maximum-paths command.
Parameters
ebgp Enter the keyword ebgp to enable multipath support for External BGP
routes.
ibgp Enter the keyword ibgp to enable multipath support for Internal BGP
routes.
number Enter a number as the maximum number of parallel paths. The S4810
range is 2 to 64.
Defaults none
Command Modes ROUTER BGP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.8.0 Support 2 to 64 paths on the S4810. Command syntax changed to
max-path (was maximum-paths).
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
If you enable this command, use the clear ip bgp * command to recompute the best
path.
478