Dell Force10 Z9000 - Upgrade (C-Series Version)

FTOS(conf)#int te 0/5
FTOS(conf-if-te-0/5)#no shut
FTOS(conf-if-te-0/5)#
FTOS(conf-if-te-0/5)#
FTOS(conf-if-te-0/5)#
FTOS(conf-if-te-0/5)#ipv6 nd prefix FEC0::/10
FTOS(conf-if-te-0/5)#
FTOS(conf-if-te-0/5)#show conf
!
interface TenGigabitEthernet 0/5
ip address 78.21.1.3/24
ipv6 nd prefix fec0::/10
flowcontrol rx on tx on
no shutdown
FTOS(conf-if-te-0/5)#
FTOS#
upgrade (C-Series version)
Upgrade the bootflash or boot selector image on a processor.
C-Series
Syntax
upgrade {bootflash-image | bootselector-image | system-image}
{all | linecard {number | all} | rpm} [booted | file-url |
repair]
Parameters
bootflash-image Enter the keyword bootflash-image to upgrade the bootflash
image.
bootselector-
image
Enter the keyword bootselector-image to upgrade the boot
selector image. Use with TAC supervision only.
system-image Enter the keyword system-image to upgrade the system image.
Use with TAC supervision only.
all
• Enter the keyword all to upgrade the bootflash or boot
selector image on all processors. This keyword does not
upgrade the bootflash on the standby RPM.
• Enter the keyword all after the keyword linecard to
upgrade the bootflash or boot selector image on all linecards.
linecard number Enter the keyword linecard followed by the line card slot number.
Range: 0 to 7 for the C300 and 0 to 2 for the C150.
rpm Enter the keyword rpm to upgrade the system image of a selector
image on all processors on the RPM.
repair Enter this keyword repair to upgrade a line card newly inserted
into an already upgraded chassis. This option is only available with
the system-image keyword.
87