Default: 20
metric-type
type-
value
(OPTIONAL) Enter the keyword metric-type followed by the OSPFv3
link state type of 1 or 2 for default routes. The values are:
1 = Type 1 external route
2 = Type 2 external route
Default: 2
route-map
map-
name
(OPTIONAL) Enter the keyword route-map followed by the name of an
established route map. If the route map is not configured, the default
is deny (to drop all routes).
tag
tag-value
(OPTIONAL) Enter the keyword tag to set the tag for routes
redistributed into OSPFv3.
Range: 0 to 4294967295
Default: 0
Defaults Not configured.
Command Modes
ROUTER OSPF for OSPFv2
ROUTER OSPFv3 for OSPFv3
Command History
Version 9.1.(0.0) Introduced support for OSPFv3 on the S4810 and Z9000.
Version 7.8.1.0 Added support for the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
To redistribute the default route (x:x:x:x::x), configure the default-information originate
command.
Related
Commands
default-
information
originate
Configure default external route into OSPFv3.
router-id
Designate a fixed router ID.
C-Series, E-Series, Z-Series, S4810
Syntax
router-id ip-address
To return to the previous router ID, use the no router-id
ip-address
command.
Parameters
ip-address
Enter the router ID in the dotted decimal format.
1120
To Next Page
Loading...
