Dell Force10 Z9000 - Resequence Access-List

1 0000000000000000 1111110000000000 0 1023 1024
Total Ports: 1024
Related
Commands
ip access-list extended – creates an extended ACL.
permit – assigns a permit filter for IP packets.
permit tcp – assigns a permit filter for TCP packets.
resequence access-list
Re-assign sequence numbers to entries of an existing access-list.
C-Series, E-Series, S-Series, Z-Series
Syntax
resequence access-list {ipv4 | mac} {access-list-name
StartingSeqNum Step-to-Increment}
Parameters
ipv4 | mac Enter the keyword ipv4or mac to identify the access list type to
resequence.
access-list-name Enter the name of a configured IP access list, up to 140 characters.
StartingSeqNum Enter the starting sequence number to resequence. The range is 0 to
4294967290.
Step-to-
Increment
Enter the step to increment the sequence number. The range is 1 to
4294967290.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale (IPv4).
Version 7.8.1.0 Increased the name string to accept up to 140 characters. Prior to
7.8.1.0, names were up to 16 characters long.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
When all sequence numbers have been exhausted, this feature permits re-assigning a new
sequence number to entries of an existing access-list.
Related
Commands
resequence prefix-list ipv4 – resequences a prefix list.
254