Dell Force10 Z9000 Reference Guide

disable
Disable the DHCP server.
C-Series, S-Series, Z-Series, S4810
Syntax
disable
DHCP Server is disabled by default. Enable the system to be a DHCP server using the no
disable command.
Defaults Disabled
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series and S-Series.
dns-server
Assign a DNS server to clients based on address pool.
C-Series, S-Series, Z-Series, S4810
Syntax
dns-server address [address2...address8]
Parameters
address Enter the a list of DNS servers that may service clients on the subnet.
You may list up to eight servers, in order of preference.
Defaults none
Command Modes DHCP <POOL>
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series and S-Series.
domain-name
Assign a domain to clients based on the address pool.
C-Series, S-Series, Z-Series, S4810
Syntax
domain-name name
Parameters
name Give a name to the group of addresses in a pool.
593

Dell Force10 Z9000 Specifications

General

Switching Capacity	2.56 Tbps
Power Supply	Dual, hot-swappable
MTBF	200, 000 hours
Ports	32 x 40GbE QSFP+
Cooling	Front-to-back airflow
Form Factor	Fixed
Jumbo Frame Support	Up to 9216 bytes
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Humidity	10% to 90% (non-condensing)
MAC Address Table Size	128K
Dimensions (HxWxD)	3.45 in x 17.32 in x 20.0 in