Dell Force10 Z9000 - Show Ip Bgp Ipv4 Multicast

To stop redistribution of OSPF routes, use the no redistribute ospf process-id
command.
Parameters
process-id Enter the number of the OSPF process. The range is 1 to 65535.
match external {1
| 2}
(OPTIONAL) Enter the keywords match external to redistribute
OSPF external routes. You can specify 1 or 2 to redistribute those
routes only.
match internal (OPTIONAL) Enter the keywords match internal to redistribute
OSPF internal routes only.
route-map map-
name
(OPTIONAL) Enter the keywords route-map followed by the name
of a configured route map.
Defaults Not configured.
Command Modes ROUTER BGP Address Family (conf-router_bgp_af)
Command History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced IPv6 MGBP on the E-Series.
Usage
Information
When you enter the redistribute isis process-id command without any other
parameters, FTOS redistributes all OSPF internal routes, external type 1 routes, and external
type 2 routes. This feature is not supported by an RFC.
This feature is not supported by an RFC.
show ip bgp ipv4 multicast
View the current MBGP routing table for the system.
C-Series, E-Series TeraScale, S-Series
Syntax
show ip bgp ipv4 multicast [detail | network [network-mask]
[length]]
Parameters
detail (OPTIONAL) Enter the keyword detail to display BGP internal
information for the IPv4 Multicast address family.
network (OPTIONAL) Enter the network address (in dotted decimal format) of
the BGP network to view information only on that network.
network-mask (OPTIONAL) Enter the network mask (in slash prefix format) of the
BGP network address.
longer-prefixes (OPTIONAL) Enter the keywords longer-prefixes to view all
routes with a common prefix.
Command Modes
• EXEC
• EXEC Privilege
433