cp (OPTIONAL) Enter the cp to clear only statistics from the Control
Processor.
rp1 (OPTIONAL) Enter the keyword rp1 to clear only the statistics from
Route Processor 1.
rp2 (OPTIONAL) Enter the keyword rp2 to clear only the statistics from
Route Processor 2.
Command Modes EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
debug arp
View information on ARP transactions.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
debug arp [interface] [count value]
To stop debugging ARP transactions, use the no debug arp command.
Parameters
interface
(OPTIONAL) Enter the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For the Management interface, enter the keyword
ManagementEthernet followed by the slot/port
information. The slot range is 0 to 1 and the port range is 0.
• For a Port Channel interface, enter the keywords port-
channel followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword sonet followed by
the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
777
To Next Page
Loading...
