Dell Force10 Z9000 - Dot1 X Server-Timeout; Dot1 X Supplicant-Timeout

To return to the default, use the no dot1x reauth-max command.
Parameters
number Enter the permitted number of re-authentications. The range is 1 - 10.
The default is 2.
Defaults 2
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
Version 7.4.1.0 Introduced on the E-Series.
dot1x server-timeout
Configure the amount of time after which exchanges with the server time out.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
dot1x server-timeout seconds
To return to the default, use the no dot1x server-timeout command.
Parameters
seconds Enter a time-out value in seconds. The range is 1 to 300, where 300 is
implementation dependant. The default is 30.
Defaults 30 seconds
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
Version 7.4.1.0 Introduced on the E-Series.
dot1x supplicant-timeout
Configure the amount of time after which exchanges with the supplicant time out.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
dot1x supplicant-timeout seconds
To return to the default, use theno dot1x supplicant-timeout command.
Parameters
seconds Enter a time-out value in seconds. The range is 1 to 300, where 300 is
implementation dependant. The default is 30.
1321