Dell Force10 Z9000 - Show Ip Ospf; Show Config

After the OSPF process and the VRF are tied together, you cannot use the OSPF Process ID
again in the system.
Example
FTOS(conf)#router ospf 2
FTOS(conf-router_ospf)#
show config
Display the non-default values in the current OSPF configuration.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show config
Command Modes ROUTER OSPF
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Example
FTOS(conf-router_ospf)#show config
!
router ospf 3
passive-interface FastEthernet 0/1
FTOS(conf-router_ospf)#
show ip ospf
Display information on the OSPF process configured on the switch.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show ip ospf process-id [vrf vrf name]
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no Process
ID is entered, command applies only to the first OSPF process.
vrf name E-Series Only: Show only the OSPF information tied to the VRF
process.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
1072