Dell Force10 Z9000 - Show Monitor Session

Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Example
FTOS(conf-mon-sess-11)#show config
!
monitor session 11
source GigabitEthernet 10/0 destination GigabitEthernet
10/47 direction rx
FTOS#
show monitor session
Display the monitor information of a particular session or all sessions.
C-Series, E-Series, S-Series, Z-Series
Syntax
show monitor session {session-ID}
To display monitoring information for all sessions, use the show monitor session
command.
Parameters
session-ID (OPTIONAL) Enter a session identification number. The range 0 to
65535.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Example
FTOS#show monitor session 11
SessionID Source Destination Direction Mode
--------- ------ ------------- --------- -------
11 Gi 10/0 Gi 10/47 rx interface
1152