Dell Force10 Z9000 - Match Community

Command Modes ROUTE-MAP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Increased the name string to accept up to 140 characters. Prior to
7.8.1.0, names are up to 16 characters long.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Related
Commands
set as-path – adds information to the BGP AS_PATH attribute.
match community
Configure a filter to match routes that have a certain COMMUNITY attribute in their BGP path.
C-Series, E-Series, S-Series, Z-Series
Syntax
match community community-list-name [exact]
To delete a community match filter, use the no match community command.
Parameters
community-list-
name
Enter the name of a configured community list.
exact (OPTIONAL) Enter the keywords exact to process only those routes
with this community list name.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Related
Commands
ip community-list – configures an Community Access list.
set community – specifies a COMMUNITY attribute.
neighbor send-community – sends COMMUNITY attribute to peer or peer group.
285