Dell Force10 Z9000 - Show Ipv6 Cam Stack-Unit

Prefix First-Hop Mac-Addr Port VId EC
----------------------------------------------------------
[ 4096] 500::/64 : : 0 0 :00:00:00:00:00 CP 0 0
[ 4096] 700::/64 : : 0 0 :00:00:00:00:00 CP 0 0
FTOS#
show ipv6 cam stack-unit
Displays the IPv6 CAM entries for the specified stack-unit.
S-Series, Z-Series, S4810
Syntax
show ipv6 cam stack-unit unit-number port-set {0-1} [summary |
index | ipv6 address]
Parameters
unit-number Enter the stack unit’s ID number. The range is 0 to 11.
port-set Enter the keyword Port Set.
summary (OPTIONAL) Enter the keyword summary to display a table listing
network prefixes and the total number prefixes which can be entered
into the IPv6 CAM.
index (OPTIONAL) Enter the index in the IPv6 CAM.
ipv6-address Enter the IPv6 address in the x:x:x:x::x/n format to display networks
that have more specific prefixes. The range is /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.7.1 Introduced on the S4810.
Version 8.4.2.1 Introduced on the S-Series.
Usage
Information
On the S4810, First-Hop information is not shown for installed routes in the IPv6 content
addressable memory (CAM). However, the same is shown in the forwarding information base
(FIB).
847