• Transmit timer remaining value for each neighbor
• The LSU Q length and its highest mark for each neighbor
• The LSR Q length and its highest mark for each neighbor
Example
(Statistics)
FTOS#show ip ospf 100 statistics
Interface GigabitEthernet 0/8
Hello-Timer 9, Wait-Timer 0, Grace-Timer 0
Error packets (Only for RX)
Intf-Down 0 Non-Dr 0 Self-Org 0
Wrong-Len 0 Invld-Nbr 0 Nbr-State 0
Auth-Error 0 MD5-Error 0 Cksum-Err 0
Version 0 AreaMisMatch 0 Conf-Issue 0
SeqNo-Err 0 Unkown-Pkt 0
Neighbor ID 9.1.1.2
Hello DDiscr LSReq LSUpd LSAck
RX 59 3 1 1 1
TX 62 2 1 0 0
Dead-Timer 37, Transmit-Timer 0
LSU-Q-Len 0, LSU-Q-Wmark 0
LSR-Q-Len 0, LSR-Q-Wmark 1
Related
Commands
clear ip ospf statistics – clears the packet statistics in all interfaces and neighbors.
show ip ospf timers rate-limit
Show the LSA currently in the queue waiting for timers to expire.
Z-Series, S4810
Syntax
show ip ospf process-id timers rate-limit
Parameters
process-id
Enter the OSPF Process ID to show a specific process. If no Process
ID is entered, command applies only to the first OSPF process.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.8.0 Introduced on the S4810.
Example
FTOS#show ip ospf 10 timers rate-limit
List of LSAs in rate limit Queue
LSA id: 1.1.1.0 Type: 3 Adv Rtid: 3.3.3.3 Expiry time:
1098
To Next Page
Loading...
