Dell Force10 Z9000 - Ip Fib Download-Igp-Only

Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Usage
Information
You can only configure one domain name with the ip domain-name command. To
configure more than one domain name, configure the ip domain-list command up to six
times.
Use the following steps to enable dynamic resolution of hosts:
• specify a domain name server with the ip name-server command
• enable DNS with the ip domain-lookup command
To view current bindings, use the show hosts command.
Related
Commands
ip domain-list – configures additional names.
ip fib download-igp-only
Configure the E-Series to download only IGP routes (for example, OSPF) on to line cards. When the command is
configured or removed, it clears the routing table (similar to the clear ip route command) and only IGP routes
populate the table.
E-Series
Syntax
ip fib download-igp-only [small-fib]
To return to default setting, use the no ip fib download-igp-only [small-fib]
command.
Parameters
small-fib (OPTIONAL) Enter the keyword small-fib to download a smaller
FIB table. This option is useful on line cards with a limited FIB size.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
787