Dell Force10 Z9000 - Common IP ACL Commands; Access-Class; Clear Counters Ip Access-Group

Common IP ACL Commands
The following commands are available within both IP ACL modes (Standard and Extended) and do not have mode-
specific options. When an ACL is created without a rule and then is applied to an interface, ACL behavior reflects an
implicit permit.
C-Series and S-Series (non-S4810) platforms support Ingress IP ACLs only.
The S4810 and Z-Series support both Ingress and Egress IP ACLs.
NOTE: Also refer to the Commands Common to all ACL Types section.
access-class
Apply a standard ACL to a terminal line.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
access-class access-list-name
To remove an ACL, use the no access-class access-list-name command.
Parameters
access-list-name Enter the name of a configured Standard ACL, up to 140 characters.
Defaults Not configured.
Command Modes LINE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Increase the name string to accept up to 140 characters. Prior to
7.8.1.0, names were up to 16 characters long.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
clear counters ip access-group
Erase all counters maintained for access lists.
C-Series, E-Series, S-Series, Z-Series
Syntax
clear counters ip access-group [access-list-name]
Parameters
access-list-name (OPTIONAL) Enter the name of a configured access-list, up to 140
characters.
214