Dell Force10 Z9000 - Logging Coredump Stack-Unit

Version 7.7.1.0 Restructured the command to accommodate core dumps for CP.
Introduced on the C-Series and S-Series.
Version 6.1.1.0 Introduced
Usage
Information
You must use this command to enable core dump logging before a software exception occurs.
If the FTP server is unreachable, FTOS aborts the application core dump.
When you enable this command to allow the system to automatically upload application core
dumps to an FTP server, you are requested to enter a username and password. Use the
username and password of the FTP server where the core files are being moved. The
password can be up to 15 alphanumeric characters only; no special characters are allowed.
After you enter the password, an FTP URL is created with the credentials in the operating
system. The CLI monitors application core dumps in the unit. Any application core dumps that
occur are automatically uploaded to the FTP server.
Because flash space may be limited, using this command ensures your entire crash kernel files
are uploaded successfully and completely. You can only configure a single coredump server.
Configuration of a new coredump server over-writes any previously configured server.
NOTE: You must disable logging coredump before you designate a new server destination
for your core dumps.
Related
Commands
logging coredump – enables coredump.
logging coredump stack-unit
Enable coredump on a stack.
S-Series, Z-Series, S4810
Syntax
logging coredump stack-unit {all}
Parameters
all Enable coredump on a stack.
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.10.1 Introduced on the S4810.
Usage
Information
When you enable this command to allow the system to automatically upload application core
dumps to an FTP server, you are requested to enter a username and password. Use the
username and password of the FTP server where the core files are being moved. The
password can be up to 15 alphanumeric characters only; no special characters are allowed.
After the password is entered, an FTP URL is created with the credentials in the operating
system. The CLI monitors application core dumps in the unit. Any application core dumps that
occur are automatically uploaded to the FTP server.
Related
Commands
logging coredump – designates a server to upload kernel core-dumps.
569