Dell Force10 Z9000 - Show Tcp Statistics

17 UDP any 21 Q7 6 No - CP
18 UDP any 20 Q7 6 No - CP
19 TCP 21 any Q7 6 No - CP
20 TCP 20 any Q7 6 No - CP
21 UDP 21 any Q7 6 No - CP
22 UDP 20 any Q7 6 No - CP
23 UDP any 69 Q7 6 No - CP
24 UDP 69 any Q7 6 No - CP
25 TCP any 161 Q7 6 No - CP
26 TCP 161 any Q7 6 No - CP
27 TCP 162 any Q7 6 No - CP
28 TCP any 162 Q7 6 No - CP
29 UDP any 161 Q7 6 No - CP
30 UDP 161 any Q7 6 No - CP
31 UDP any 162 Q7 6 No - CP
32 UDP 162 any Q7 6 No - CP
33 PIM-SM any any Q6 0 No - RP2
34 IGMP any any Q7 6 No - RP2
35 OSPF any any Q7 6 No - RP1
Related
Commands
show ip cam stack-unit – displays the CAM table.
show tcp statistics
View information on TCP traffic through the switch.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show tcp statistics {all | cp | rp1 | rp2}
Parameters
all Enter the keyword all to view all TCP information.
cp Enter the keyword cp to view only TCP information from the Control
Processor.
rp1 Enter the keyword rp1 to view only TCP statistics from Route
Processor 1.
rp2 Enter the keyword rp2 to view only TCP statistics from Route
Processor 2.
Command Modes EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 6.4.1.0 Introduced
Usage
Information
The following describes the show tcp statistics cp command shown in the Example
below.
831