Dell Force10 Z9000 - Aaa Authorization Config-Commands

name Define a name for the list of authorization methods.
default Define the default list of authorization methods.
local Use the authorization parameters on the system to perform
authorization.
tacacs+ Use the TACACS+ protocol to perform authorization.
none Enter the keyword none to apply no authorization.
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.1.1.0 Added support for RADIUS.
aaa authorization config-commands
Set parameters that restrict (or permit) a user’s access to EXEC level commands.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
aaa authorization config-commands
Disable authorization checking for CONFIGURATION level commands using the no aaa
authorization config-commands command.
Defaults Enabled when you configure aaa authorization commands command.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the E-Series.
Usage
Information
By default, the aaa authorization commands command configures the system to
check both EXEC level and CONFIGURATION level commands. Use the command no aaa
authorization config-commands
to enable only EXEC-level command checking.
1290