Dell Force10 Z9000 - Storm-Control Multicast (Interface)

storm-control multicast (Configuration)
Configure the packets per second (pps) of multicast traffic allowed in to the C-Series and S-Series networks only.
C-Series, S-Series, Z-Series, S4810
Syntax
storm-control multicast packets_per_second in
To disable storm-control for multicast traffic into the network, use the no storm-control
multicast packets_per_second in command.
Parameters
packets_per_sec
ond in
C-Series and S-Series Only: Enter the packets per second of multicast
traffic allowed into the network. The range is 0 to 33554431.
Defaults none
Command Modes CONFIGURATION (conf)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the C-series and S-Series.
Usage
Information
Broadcast traffic (all 0xFs) should be counted against the broadcast storm control meter, not
against the multicast storm control meter. It is possible, however, that some multicast control
traffic may get dropped when storm control thresholds are exceeded.
storm-control multicast (Interface)
Configure the percentage of multicast traffic allowed on an C-Series or S-Series interface (ingress only) network only.
C-Series, S-Series, Z-Series, S4810
Syntax
storm-control multicast packets_per_second in
To disable multicast storm control on the interface, use the no storm-control
multicast packets_per_second in command.
Parameters
packets_per_sec
ond in
C-Series and S-Series Only: Enter the packets per second of
broadcast traffic allowed into the network. The range is 0 to 33554431.
Defaults none
Command Modes INTERFACE (conf-if- interface-slot/port )
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
1407