Adv rcvd: 0, Adv sent: 1862, Gratuitous ARP sent: 0
Virtual MAC address:
00:00:5e:00:01:01
Virtual IP address:
10.1.1.252
Authentication: (none)
Tracking states for 1 interfaces:
Up GigabitEthernet 12/17 priority-cost 10
------------------
GigabitEthernet 12/4, VRID: 2, Net: 10.1.2.253
State: Master, Priority: 110, Master: 10.1.2.253 (local)
Hold Down: 10 sec, Preempt: TRUE, AdvInt: 1 sec
Adv rcvd: 0, Adv sent: 1862, Gratuitous ARP sent: 0
Virtual MAC address:
00:00:5e:00:01:02
Virtual IP address:
10.1.2.252
Authentication: (none)
Tracking states for 2 interfaces:
Up GigabitEthernet 2/1 priority-cost 10
Up GigabitEthernet 12/17 priority-cost 10
FTOS>
track
Monitor an interface and lower the priority value of the VRRP group on that interface if it is disabled.
C-Series, E-Series, S-Series (S50)
Syntax
track interface [priority-cost cost]
To disable monitoring, use the no track interface command.
Parameters
interface
(OPTIONAL) Enter the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For Port Channel interface types, enter the keywords port-
channel followed by the number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale.
• For SONET interfaces, enter the keyword sonet followed by
the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
FortyGigabitEthernet followed by the slot/port
information.
• For a VLAN interface, enter the keyword vlan followed by
the VLAN ID. The VLAN ID range is from 1 to 4094.
1480
To Next Page
Loading...
