NOTE: Designate the milliseconds in multiples of 100.
Defaults As above.
Command Modes CONFIGURATION-GVRP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on C-Series, E-Series, and S-Series
Usage
Information
• Join Timer—Join messages announce the willingness to register some attributes
with other participants. For reliability, each GARP application entity sends a Join
message twice and uses a join timer to set the sending interval.
• Leave Timer—Leave announces the willingness to de-register with other
participants. Together with Join, Leave messages help GARP participants complete
attribute reregistration and de-registration. The leave timer starts after receipt of a
leave message sent for de-registering some attribute information. If a
Join message
is
not
received before the Leave time expires, the GARP application entity removes
the attribute information as requested.
• Leave All Timer—The Leave All timer starts when a GARP application entity starts.
When this timer expires, the entity sends a Leave-all message so that other
entities can reregister their attribute information. Then the
Leave-all time begins
again.
Related
Commands
show garp timers – displays the current GARP times.
gvrp enable
Enable GVRP on physical interfaces and LAGs.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
gvrp enable
To disable GVRP on the interface, use the no gvrp enable command.
Defaults Disabled.
Command Modes CONFIGURATION-INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on C-Series, E-Series, and S-Series
Related
Commands
disable – globally disables GVRP.
653
To Next Page
Loading...
