Dell Force10 Z9000 - Forward-Delay; Disable

disable
Globally disable the multiple spanning tree protocol on the switch.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
disable
To enable MSTP, enter the no disable command.
Defaults disabled.
Command Modes MULTIPLE SPANNING TREE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.5.1.0 Introduced.
Related
Commands
spanning-tree mstp – enters MULTIPLE SPANNING TREE mode.
forward-delay
The amount of time the interface waits in the Blocking State and the Learning State before transitioning to the
Forwarding State.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
forward-delay seconds
To return to the default setting, use the no forward-delay command.
Parameters
seconds Enter the number of seconds the interface waits in the Blocking State
and the Learning State before transiting to the Forwarding State. The
range is 4 to 30. The default is 15 seconds.
Defaults 15 seconds
Command Modes MULTIPLE SPANNING TREE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
993