...............................................................
.....................................
...............................................................
.....................................
...............................................................
.....................................
...............................................................
.....................................
....................................!
12946259 bytes successfully copied
FTOS# reload
upgrade fpga-image
You can use this command can only on systems with SFM3 modules (and only when required by the upgrade procedure
in the release notes). Upgrade the FPGA version in the specified E-Series SFM3 and automatically initiate an automatic
reset to complete the version upgrade.
E-Series, Z-Series
Syntax
upgrade fpga-image {sfm} {all | id} [booted | flash:// | ftp: |
slot0: | tftp] file-url
Parameters
sfm Enter the keyword sfm to upgrade the FPGA on the SFMs.
all Enter the keyword all to upgrade the FPGA on all the SFMs.
id Enter the keyword id to upgrade the FPGA on all a specific SFM.
booted Enter the path to the upgrade source. Entering <CR> updates the
FPGA from the flash.
file-url
Enter the following location keywords and information to upgrade the
FPGA using an FTOS image other than the one currently running:
• To specify an FTOS image on the internal flash, enter
flash:// file-path/filename.
• To specify an FTOS image on an FTP server, enter ftp://
user:password@hostip/filepath.
• To specify an FTOS image on the external flash on the
primary RPM, enter slot0://file-path/filename.
• To copy a file on a TFTP server, enter tftp://hostip/
filepath/ filename where hostip is either an IPv4
dotted decimal address or an IPv6 URI [x:x:x:x::x] format
address..
Defaults none
Command Modes EXEC Privilege
Command History
Version 9.0.0.0 Introduced on the Z-Series.
92
To Next Page
Loading...
