EasyManua.ls Logo

Dell Force10 Z9000 - Mac-Address-Table Static

Dell Force10 Z9000
1483 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
show mac-address-table aging-time – displays the MAC aging time.
mac-address-table static
Associate specific MAC or hardware addresses to an interface and VLANs.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
mac-address-table static mac-address {multicast vlan vlan-id
output—range interface}{output interface vlan vlan-id}
To remove a MAC address, use the no mac-address-table static mac-address
output interface vlan vlan-id command.
Parameters
mac-address
Enter the 48-bit hexidecimal address in nn:nn:nn:nn:nn:nn format.
multicast
Enter a vlan port to where L2 multicast MAC traffic is forwarded.
NOTE: Use this option if you need to have multicast functionality
in an L2 VLAN without IGMP protocols.
output
interface
For a unicast MAC address, enter the keyword output followed by
one of the following interfaces for which traffic needs to be
forwarded:
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
For a Port Channel interface, enter the keywords port-
channel followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
For a SONET interface, enter the keyword sonet followed by
the slot/port information.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
output-range
interface
For a multicast MAC address, enter the keyword output-range
followed by one of the following interfaces to indicate a range of
ports for which traffic needs to be forwarded:
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
For a Port Channel interface, enter the keywords port-
channel followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
918

Table of Contents

Other manuals for Dell Force10 Z9000

Related product manuals