Dell Force10 Z9000 - Private-Vlan Mapping Secondary-Vlan; Show Interfaces Private-Vlan

private-vlan mapping secondary-vlan
Map secondary VLANs to the selected primary VLAN.
C-Series, S-Series, Z-Series, S4810
Syntax
[no] private-vlan mapping secondary-vlan vlan-list
To remove specific secondary VLANs from the configuration, use the no private-vlan
mapping secondary-vlan vlan-list command syntax.
Parameters
vlan-list Enter the list of secondary VLANs to associate with the selected
primary VLAN. The list can be in comma-delimited or hyphenated-
range format, following the convention for the range input.
Defaults none
Command Modes INTERFACE VLAN
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the C-Series and S-Series.
Usage
Information
The list of secondary VLANs can be:
• Specified in comma-delimited or hyphenated-range format.
• Specified with this command even before they have been created.
• Amended by specifying the new secondary VLAN to be added to the list.
Related
Commands
private-vlan mode – sets the mode of the selected VLAN to community, isolated, or primary.
show interfaces private-vlan – displays the type and status of the PVLAN interfaces.
show vlan private-vlan – displays the PVLANs and/or interfaces that are part of a PVLAN.
show vlan private-vlan mapping – displays the primary-secondary VLAN mapping.
switchport mode private-vlan – sets PVLAN mode of the selected port.
show interfaces private-vlan
Display type and status of PVLAN interfaces.
C-Series, S-Series
Syntax
show interfaces private-vlan [interface interface]
1160