Dell Force10 Z9000 - Show Cpu-Queue Rate Cp; Show Ip Protocol-Queue-Mapping

show cpu-queue rate cp
Display the rates for each queue.
Z-Series, S4810
Syntax
show cpu-queue rate cp
Defaults Not configured.
Command Modes EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.8.0 Introduced on the S4810.
Usage
Information
This command applies the service-policy based on the type of protocol defined in the ACL
rules.
You must create ACL and QoS policies prior to enabling this command.
Example
FTOS#show cpu-queue rate cp
Service-Queue Rate (PPS)
-------------- -----------
Q0 1300
Q1 300
Q2 300
Q3 300
Q4 2000
Q5 400
Q6 400
Q7 1100
FTOS#
show ip protocol-queue-mapping
Display the queue mapping for each configured protocol.
Z-Series, S4810
Syntax
show ip protocol-queue-mapping
Defaults Not configured.
Command Modes EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.8.0 Introduced on the S4810.
Example
FTOS#show ip protocol-queue-mapping
Protocol Src-Port Dst-Port TcpFlag Queue EgPort
563