Dell Force10 Z9000 - Ip Pim Query-Interval; Ip Pim Register-Filter

ip pim query-interval
Change the frequency of PIM Router-Query messages.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
ip pim query-interval seconds
To return to the default value, use the no ip pim query-interval seconds
command.
Parameters
seconds Enter a number as the number of seconds between router query
messages. The range: 0 to 65535. The default is 30 seconds.
Defaults 30 seconds
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series for the port-channels and the S-Series.
ip pim register-filter
Use this feature to prevent a PIM source DR from sending register packets to an RP for the specified multicast source
and group.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
ip pim register-filter access-list
To return to the default, use the no ip pim register-filter access-list
command.
Parameters
access-list Enter the name of an extended access list. Maximum 16 characters.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the C-Series and S-Series.
1135