Dell Force10 Z9000 - Clear Ip Rip; Debug Ip Rip

clear ip rip
Update all the RIP routes in the FTOS routing table.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
clear ip rip
Command Modes EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
This command triggers updates of the main RIP routing tables.
debug ip rip
Examine RIP routing information for troubleshooting.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
debug ip rip [interface | database | events [interface] |
packet [interface] | trigger]
To turn off debugging output, use the no debug ip rip command.
Parameters
interface (OPTIONAL) Enter the interface type and ID as one of the following:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel
followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword sonet followed by
the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
1236