To remove RMON MIB statistics collection on an interface, use the no rmon collection
statistics {controlEntry integer} command.
Parameters
controlEntry
integer
Enter the keyword controlEntry to specify the RMON group of
statistics using a value. Then enter an integer value from 1 to 65535
that identifies the RMON Statistic Table. The integer value must be a
unique in the RMON statistic table.
owner
name
(OPTIONAL) Enter the keyword owner followed by the owner name
to record the owner of the RMON group of statistics.
Defaults none
Command Modes CONFIGURATION INTERFACE (config-if)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.1.1.0 Introduced on the E-Series.
rmon event
Add an event in the RMON event table.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
rmon event number [log] [trap community] [description string]
[owner name]
To disable RMON on an interface, use the no rmon event number [log] [trap
community] [description string] command.
Parameters
number
Assign an event number in integer format from 1 to 65535. The number
value must be unique in the RMON event table.
log (OPTIONAL) Enter the keyword log to generate an RMON log entry.
The log entry is triggered and sets the eventType in the RMON MIB to
log or log-and-trap. The default is No log.
trap
community
(OPTIONAL) Enter the keyword trap followed by an SNMP
community string to configure the eventType setting in the RMON
MIB. This sets either snmp-trap or log-and-trap. The default is public.
description
string
(OPTIONAL) Enter the keyword description followed by a string
describing the event.
1262
To Next Page
Loading...
