Dell Force10 Z9000 - Rate-Police

peak peak-rate (OPTIONAL) Enter the keyword peak followed by a number to specify
the peak rate in Mbps. The range is 0 to 10000. The default is the
same as designated for committed-rate.
Defaults Burst size is 50 KB. peak-rate is by default the same as committed-rate. Granularity
for
committed-rate and peak-rate is Mbps unless you use the kbps option.
Command Modes QOS-POLICY-OUT
Command History
Version 8.2.1.0 Added the kbps option on the E-Series.
Version 7.7.1.0 Removed from the C-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Related
Commands
rate limit – specifies the rate-limit functionality on the selected interface.
qos-policy-output – creates a QoS output policy.
rate-police
Specify the policing functionality on incoming traffic.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
rate-police [kbps] committed-rate [burst-KB] [peak [kbps] peak-
rate [burst-KB]]
Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits per
second (Kbps). On C-Series and S-Series, make the following value a
multiple of 64. On the E-Series, Force10 recommends using a value
greater than or equal to 512 as lower values does not yield accurate
results. The range is 0 to 10000000. The default granularity is
Megabits per second (Mbps).
committed-rate Enter the bandwidth in Mbps. The range is 0 to 10000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is 16 to 200000. The
default is 50.
peak peak-rate (OPTIONAL) Enter the keyword peak followed by a number to specify
the peak rate in Mbps. The range is 0 to 10000. The default is the
same as designated for committed-rate.
Defaults Burst size is 50 KB. peak-rate is by default the same as committed-rate. Granularity
for committed-rate and peak-rate is Mbps unless you use the kbps option.
Command Modes QOS-POLICY-IN
1209