Dell Force10 Z9000 - Neighbor Shutdown

To disable sending a COMMUNITY attribute, use the no neighbor {ip-address |
peer-group-name} send-community command.
Parameters
ip-address Enter the IP address of the peer router in dotted decimal format.
peer-group-name Enter the name of the peer group to send a COMMUNITY attribute to
all routers within the peer group.
extended Optional. Enter the keyword extended to send extended community
attribute.
standard Optional. Enter the keyword standard to send standard community
attribute.
Defaults Not configured and COMMUNITY attributes are not sent to neighbors.
Command Modes ROUTER BGP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
To configure a COMMUNITY attribute, use the set community command in ROUTE-MAP
mode.
neighbor shutdown
Disable a BGP neighbor or peer group.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
neighbor {ip-address | peer-group-name} shutdown
To enable a disabled neighbor or peer group, use the neighbor {ip-address |
peer-group-name} no shutdown command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to disable or enable all routers
within the peer group.
Defaults Enabled (that is, BGP neighbors and peer groups are disabled.)
Command Modes ROUTER BGP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
376