Dell Force10 Z9000 - Ip Domain-List

Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
ip domain-list
Configure names to complete unqualified host names.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
ip domain-list name
To remove the name, use the no ip domain-list name command.
Parameters
name Enter a domain name to be used to complete unqualified names (that
is, incomplete domain names that cannot be resolved).
Defaults Disabled.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Usage
Information
Configure the ip domain-list command up to six times to configure a list of possible
domain names.
If you configure both the ip domain-name and ip domain-list commands, the
software tries to resolve the name using the ip domain-name command. If the name is not
resolved, the software goes through the list of names configured with the ip domain-list
command to find a match.
Use the following steps to enable dynamic resolution of hosts:
• specify a domain name server with the ip name-server command
• enable DNS with the ip domain-lookup command
To view current bindings, use the show hosts command. To view DNS related
configuration, use the show running-config resolve command.
Related
Commands
ip domain-name – specifies a DNS server.
785