Command History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
show ip bgp ipv4 multicast neighbors
Allows you to view the information exchanged by BGP neighbors.
C-Series, E-Series TeraScale, S-Series
Syntax
show ip bgp ipv4 multicast neighbors [ip-address [advertised-
routes | dampened-routes | detail | flap-statistics | routes]]
Parameters
ip-address
(OPTIONAL) Enter the IP address, in either IPv4 or IPv6 format, of the
neighbor to view only BGP information exchanged with that neighbor.
advertised-routes (OPTIONAL) Enter the keywords advertised-routes to view
only the routes the neighbor sent.
dampened-routes (OPTIONAL) Enter the keywords dampened-routes to view
information on dampened routes from the BGP neighbor.
detail (OPTIONAL) Display detailed neighbor information.
flap-statistics (OPTIONAL) Enter the keywords flap-statistics to view flap
statistics on the neighbor’s routes.
routes (OPTIONAL) Enter the keyword routes to view only the neighbor’s
feasible routes.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced IPv6 MGBP on the E-Series.
Usage
Information
The following describes the show ip bgp ipv4 multicast neighbors command
shown in the Example below.
Lines beginning with: Description
BGP neighbor Displays the BGP neighbor address and its AS number. The last
phrase in the line indicates whether the link between the BGP router
and its neighbor is an external or internal one. If they are located in
the same AS, then the link is internal; otherwise the link is external.
BGP version Displays the BGP version (always version 4) and the remote router
ID.
439
To Next Page
Loading...
