Dell Force10 Z9000 - Show Cam Layer2-Qos

set
Mark outgoing traffic with a differentiated service code point (DSCP) or dot1p value.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
set {ip-dscp value | mac-dot1p value}
Parameters
ip-dscp value (OPTIONAL) Enter the keywords ip-dscp followed by the IP DSCP
value. The range is 0 to 63.
mac-dot1p value Enter the keywords mac-dot1p followed by the dot1p value. The
range is 0 to 7. On the C-Series and S-Series, the allowed values are:
0, 2, 4, 6.
Defaults none
Command Modes CONFIGURATION (conf-qos-policy-in)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Added mac-dot1p on the C-Series and S-Series.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 E-Series Only: Added support for mac-dot1p.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
C-Series and S-Series
After the IP DSCP bit is set, other QoS services can then operate on the bit settings.
E-Series
After the IP DSCP bit is set, other QoS services can then operate on the bit settings. Weighted
random early detection (WRED) ensures that high-precedence traffic has lower loss rates than
other traffic during times of congestion.
show cam layer2-qos
Display the Layer 2 QoS CAM entries.
E-Series
Syntax
show cam layer2-qos {[linecard number port-set number] |
[interface interface]} [summary]
1214