ip pim dr-priority
Change the designated router (DR) priority for the interface.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
ip pim dr-priority priority-value
To remove the DR priority value assigned, use the no ip pim dr-priority command.
Parameters
priority-value
Enter a number. Preference is given to larger/higher number. The
range is 0 to 4294967294. The default is 1.
Defaults 1
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series on port-channels and the S-Series.
Usage
Information
The router with the largest value assigned to an interface becomes the designated router. If
two interfaces contain the same designated router priority value, the interface with the largest
interface IP address becomes the designated router.
ip pim join-filter
Permit or deny PIM Join/Prune messages on an interface using an extended IP access list. This command prevents the
PIM-SM router from creating state based on multicast source and/or group.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
ip pim join-filter ext-access-list {in | out}
To remove the access list, use the no ip pim join-filter ext-access-list
{in | out} command.
Parameters
ext-access-list
Enter the name of an extended access list.
in Enter this keyword to apply the access list to inbound traffic.
out Enter this keyword to apply the access list to outbound traffic.
Defaults none
Command Modes INTERFACE
1133
To Next Page
Loading...
