Dell Force10 Z9000 - Sflow Enable (Interface); Sflow Extended-Gateway Enable

sflow enable (Interface)
Enable sFlow on Interfaces.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
sflow enable
To disable sFlow, use the no sflow enable command.
Defaults Disabled.
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on S-Series Stacking.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 6.2.1.1 Introduced on the E-Series.
Usage
Information
When you enable sFlow on an interface, flow sampling is done on any traffic going out of the
interface.
NOTE: After a physical port is a member of a LAG, it inherits the sFlow configuration from
the LAG port.
Related
Commands
sflow enable (Global) – turns sFlow on globally.
sflow extended-gateway enable
Enable packing information on an extended gateway.
E-Series
Syntax
sflow extended-gateway [extended-router] [extended-switch]
enable
To disable packing information, use the no sflow extended-gateway [extended-
router] [extended-switch] enable command.
Parameters
extended-router Enter the keywords extended-router to collect extended router
information.
1352