Route Map Commands
When you create an access-list without any rule and then applied to an interface, the ACL behavior reflects implicit
permit.
The following commands allow you to configure route maps and their redistribution criteria.
continue
Configure a route-map to go to a route-map entry with a higher sequence number.
C-Series, E-Series, S-Series, Z-Series
Syntax
continue [sequence-number]
Parameters
sequence-
number
(OPTIONAL) Enter the route map sequence number. The range is 1 to
65535.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
The continue feature allows movement from one route-map entry to a specific route-map
entry (the sequence number). If you do not specify the sequence number, the continue
feature simply moves to the next sequence number (also known as an implied continue). If a
match clause exists, the continue feature executes only after a successful match occurs. If
there are no successful matches, the
continue feature is ignored.
Match clause with Continue clause
The continue feature can exist without a match clause. A continue clause without a match
clause executes and jumps to the specified route-map entry.
With a match clause and a continue clause, the match clause executes first and the continue
clause next in a specified route map entry. The continue clause launches only after a
successful match. The behavior is:
• A successful match with a continue clause, the route map executes the set clauses
and then goes to the specified route map entry upon execution of the continue clause.
• If the next route map entry contains a continue clause, the route map executes the
continue clause if a successful match occurs.
• If the next route map entry does not contain a continue clause, the route map
evaluates normally. If a match does not occur, the route map does not continue and
falls through to the next sequence number, if one exists.
Set Clause with Continue Clause
283
To Next Page
Loading...
