Dell Force10 Z9000 - Ip Igmp Last-Member-Query-Interval

Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
Querier normally sends a certain number of group-specific queries when a leave message is
received for a group prior to deleting a group from the membership database. There may be
situations when you require immediate deletion of a group from the membership database. This
command provides a way to achieve the immediate deletion. In addition, this command
provides a way to enable immediate-leave processing for specified groups.
ip igmp last-member-query-interval
Change the last member query interval, which is the Max Response Time inserted into Group-Specific Queries sent in
response to Leave Group messages. This interval is also the interval between Group-Specific Query messages.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
ip igmp last-member-query-interval milliseconds
To return to the default value, use the no ip igmp last-member-query-interval
command.
Parameters
milliseconds Enter the number of milliseconds as the interval. The range is 100 to
65535. The default is 1000 milliseconds.
Defaults 1000 milliseconds
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
E-Series legacy
command
671