Dell Force10 Z9000 - Logging History Size

To return to the default values, use the no logging history command.
Parameters
level Indicate a value from 0 to 7 or enter one of the following equivalent
words: emergencies, alerts, critical, errors,
warnings, notifications, informational, or
debugging. The default is 4 or warnings.
Defaults warnings or 4
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
When you configure the snmp-server trap-source command, the system messages
logged to the history table are also sent to the SNMP network management station.
Related
Commands
show logging – displays information logged to the history buffer.
logging history size
Specify the number of messages stored in the FTOS logging history table.
C-Series, E-Series, S-Series, Z-Series
Syntax
logging history size size
To return to the default values, use the no logging history size command.
Parameters
size Indicate a value as the number of messages to be stored. The range
is 0 to 500. The default is 1 message.
Defaults 1 message
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
1386