Dell Force10 Z9000 - Show Ip Bgp Ipv6 Unicast

• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If the route map is not configured, the default is deny (to drop all
routes).
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced
Usage
Information
If you do not configure the default-metric command in addition to the redistribute
command, or there is no route map to set the metric, the metric for redistributed static and
connected is “0”.
To redistribute the default route (0::0/0), configure the neighbor default-originate
command.
Related
Commands
neighbor default-originate – injects the default route.
show ip bgp ipv6 unicast
View the current BGP routing table for the E-Series.
E-Series
Syntax
show ip bgp ipv6 unicast [network [network-mask] [length]]
Parameters
network (OPTIONAL) Enter the network address (in dotted decimal format) of
the BGP network to view information only on that network.
network-mask (OPTIONAL) Enter the network mask (in slash prefix format) of the
BGP network address.
longer-prefixes (OPTIONAL) Enter the keywords longer-prefixes to view all routes
with a common prefix.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 7.4.1.0 Introduced
Usage
Information
Field
Description
Network Displays the destination network prefix of each BGP route.
527