Dell Force10 Z9000 - Ip Igmp Query-Max-Resp-Time

Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced on the S-Series in Interface VLAN mode only to enable the
system to act as an IGMP Proxy Querier.
Version 7.5.1.0 Introduced on the C-Series in Interface VLAN mode only to enable the
system to act as an IGMP Proxy Querier.
E-Series legacy
command.
ip igmp query-max-resp-time
Set the maximum query response time advertised in general queries.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
ip igmp query-max-resp-time seconds
To return to the default values, use the no ip igmp query-max-resp-time command.
Parameters
seconds Enter the number of seconds for the maximum response time. The
range is 1 to 25. The default is 10 seconds.
Defaults 10 seconds
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced on the S-Series in Interface VLAN mode only to enable the
system to act as an IGMP Proxy Querier.
Version 7.5.1.0 Introduced on the C-Series in Interface VLAN mode only to enable the
system to act as an IGMP Proxy Querier.
E-Series legacy
command.
673