Dell Force10 Z9000 - 40 Routing Information Protocol (RIP); Auto-Summary

40
Routing Information Protocol (RIP)
Routing information protocol (RIP) is a distance vector routing protocol. The Dell Force10 operating software (FTOS)
supports both RIP version 1 (RIPv1) and RIP version 2 (RIPv2) on the C-Series, E-Series, S-Series, Z-Series, or S4810
platforms.
NOTE: The C-Series platform supports RIP with FTOS version 7.6.1.0 and later. The S-Series platform supports RIP
with FTOS version 7.8.1.0 and later. Prior to 7.6.1.0, only the E-Series platform supported RIP.
The FTOS implementation of RIP is based on IETF RFCs 2453 and RFC 1058. For more information about configuring RIP,
refer to the FTOS Configuration Guide .
auto-summary
Restore the default behavior of automatic summarization of subnet routes into network routes. This command applies
only to RIP version 2.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
auto-summary
To send sub-prefix routing information, use the no auto-summary command.
Defaults Enabled.
Command Modes ROUTER RIP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
1235