Dell Force10 Z9000 - Ip Pim Rp-Address

Version 7.6.1.0 Introduced
Usage
Information
The access name is an extended IP access list that denies PIM register packets to RP at the
source DR based on the multicast and group addresses. Do not enter this command before
creating the access-list.
ip pim rp-address
Configure a static PIM rendezvous point (RP) address for a group or access-list.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
ip pim rp-address address {group-address group-address mask}
override
To remove an RP address, use the no ip pim rp-address address {group-
address
group-address mask} override command.
Parameters
address Enter the RP address in dotted decimal format (A.B.C.D).
group-address
group-address
mask
Enter the keywords group-address followed by a group-address
mask, in dotted decimal format (/xx), to assign that group address to
the RP.
override Enter the keyword override to override the BSR updates with
static RP. The override takes effect immediately during enable/
disable.
NOTE: This option is applicable to multicast group range.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the S-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
This address is used by first-hop routers to send register packets on behalf of source multicast
hosts. The RP addresses are stored in the order in which they are entered. RP addresses
learned using BSR take priority over static RP addresses. Without the override option, RPs
advertised by the BSR updates take precedence over the statically configured RPs.
1136