Dell Force10 Z9000 - Vlan Bridge-Priority; Vlan Forward-Delay

vlan bridge-priority
Set the PVST+ bridge-priority for a VLAN or a set of VLANs.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
vlan vlan-range bridge-priority value
To return to the default value, use the no vlan bridge-priority command.
Parameters
vlan vlan-range Enter the keyword vlan followed by the VLAN number(s). The range
is 1 to 4094.
bridge-priority
value
Enter the keywords bridge-priority followed by the bridge
priority value in increments of 4096. The range is 0 to 61440. The
default is 32768.
Defaults 32768
Command Modes CONFIGURATION (conf-pvst)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.2.1.1 Introduced.
Related
Commands
vlan forward-delay – changes the time interval before FTOS transitions to the Forwarding state.
vlan hello-time – change the time interval between BPDUs.
vlan max-age – changes the time interval before PVST+ refreshes.
show spanning-tree pvst – displays the PVST+ configuration.
vlan forward-delay
Set the amount of time the interface waits in the Listening state and the Learning state before transitioning to the
Forwarding state.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
vlan vlan-range forward-delay seconds
To return to the default setting, use the no vlan forward-delay command.
Parameters
vlan vlan-range Enter the keyword vlan followed by the VLAN number(s). The range
is 1 to 4094.
1177