Dell Force10 Z9000 - Exec-Banner; Exec-Timeout

exec-banner
Enable the display of a text string when the user enters EXEC mode.
C-Series, E-Series, S-Series, Z-Series
Syntax
exec-banner
To disable the banner on terminal lines, use the no exec-banner command.
Defaults Enabled on all lines (if configured, the banner appears).
Command Modes LINE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage
Information
Optionally, use the banner exec command to create a text string that is displayed when you
access EXEC mode. This command toggles that display.
Related
Commands
banner exec – configures a banner to display when entering EXEC mode.
line – enables and configures console and virtual terminal lines to the system.
exec-timeout
Set a time interval the system will wait for input on a line before disconnecting the session.
C-Series, E-Series, S-Series, Z-Series
Syntax
exec-timeout minutes [seconds]
To return to default settings, use the no exec-timeout command.
Parameters
minutes Enter the number of minutes of inactivity on the system before
disconnecting the current session. Range: 0 to 35791. Default: 10
minutes for console line; 30 minutes for VTY line.
seconds (OPTIONAL) Enter the number of seconds Range: 0 to 2147483.
Default: 0 seconds.
Defaults 10 minutes for console line; 30 minutes for VTY lines; 0 seconds
Command Modes LINE
111