Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Example
FTOS#configure
FTOS(conf)#
debug cpu-traffic-stats
Enable the collection of computer processor unit (CPU) traffic statistics.
C-Series, E-Series, S-Series, Z-Series
Syntax
debug cpu-traffic-stats
To disable the debugging, use the no debug cpu-traffic-stats command.
Defaults Disabled
Command Modes EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.2.1.1 Introduced on the E-Series.
Usage
Information
This command enables (and disables) the collection of CPU traffic statistics from the time this
command is executed (not from system boot). However, excessive traffic received by a CPU
automatically triggers (turn on) the collection of CPU traffic statics.
The following message is an indication that collection of CPU traffic is automatically turned on.
To view the traffic statistics, use the show cpu-traffic-stats command.
If excessive traffic is received by the CPU, traffic will be rate controlled.
NOTE: This command must be enabled before the show cpu-traffic-stats
command displays traffic statistics. Dell Force10 recommends disabling debugging (no
debug cpu-traffic-stats) after troubleshooting is complete.
Related
Commands
show cpu-traffic-stats – displays the cpu traffic statistics.
104
To Next Page
Loading...
